DC power jack flex HP Omen 17-AN / 17T-AN

Do you have to wiggle the charger of your Omen 17-AN / 17T-AN (HP Omen 17-AN, HP Omen 17T-AN, ~2017-2019) to make it charge? This plug-in DC power jack swaps in under 20 minutes with no soldering. Just open the bottom, unplug the connector and slot the new one in.

Specifications

• Type: DC power jack with flex cable
• Compatible: HP Omen 17-AN, HP Omen 17T-AN
• Plug-in connector — no soldering on the motherboard
• OEM references: 924113-Y23, 926564-001
• Original connector pinning included
• Replaces the entire charging port flex assembly

Symptoms of a faulty part

• Laptop only charges if you hold the plug at a specific angle
• Battery icon flips between 'charging' and 'plugged in'
• Plug feels loose or pushes inward into the chassis
• Charge LED works sometimes but not always

Installation

🟢 Difficulty: easy. Time: about 20 minutes. Tools: Phillips screwdriver, T6 Torx, plastic spudger. Remove the bottom panel, disconnect the battery, lift the old jack out of its clip, plug in the new one and route the cable back.

Frequently asked questions

Do I need to solder?
No. This is the plug-in version. The jack clicks onto a connector on the motherboard.

Does this fit other Omen models?
It's specific to HP Omen 17-AN, HP Omen 17T-AN. Other series have a different flex length.

Will my original charger work?
Yes, the pinning matches the original — same voltage and wattage.