IPS LCD Screen with Digitizer for OnePlus Pad 2 OPD2403 (Black)

Did your OnePlus Pad 2 (OPD2403) end up with a cracked screen or a dead touch layer after a drop? Tablets take more patience than a phone because of the surface area, but this complete IPS screen assembly with digitizer gets your Pad back on its feet. The panel is finished in black to match the original front colour.

Specifications

• Compatible models: OnePlus Pad 2 OPD2403
• Type: IPS LCD with digitizer, full assembly
• Color: black
• Resolution and colour profile identical to original
• Pre-installed flex cables
• Compatible with OnePlus Stylo 2 pen
• Glossy oleophobic coating

Symptoms of a faulty part

• Tablet screen shattered across a large area
• Touch layer partly unresponsive or ghost-touching
• Pen input loses pressure sensitivity
• Vertical lines or a strip of dead pixels
• Image is dark or has a colour cast

Installation

Difficulty: 🔴 Hard (screen/soldering)
Estimated time: 120 min
Tools needed: Phillips PH00, plastic spudger, suction cup, tweezers and a heat gun or iOpener.

Frequently asked questions

Does the OnePlus Stylo 2 still work after the swap?
Yes. This digitizer supports the pressure sensitivity and low latency of the Stylo 2 with no extra setup.

How much adhesive do I need?
On a tablet far more than on a phone. Count on a full roll of B-7000 or a pre-cut adhesive kit made for the Pad 2.

Will I get the same 144Hz refresh?
Yes. The panel supports the same refresh modes as original as soon as OxygenOS boots.